![]() Ip4prefixlen expects the prefix bytes of your WAN IP to calculate the IPv6 address. Some ISP's give you the number of bytes you should use from your WAN IP to calculate your IPv6 address. config interface wan6 would result in an interface named 6rd-wan6. The interface name is derived from the section name, e.g. Logical interface template for auto-configuration of 6rdįirewall zone to which the 6rd interface should be added Type Of Service: either “inherit” (the outer header inherits the value of the inner header) or an hexadecimal value config interface sixbone would result in an interface named 6in4-sixbone.Īlthough ip6prefix isn't required, sourcefilter is enabled by default and prevents forwarding of packets unless ip6prefix is specified. This protocol type does not need the device option set in the interface section. Specifies the default route metric to use HE.net updatekey, plaintext, overrides password since 2014-02, used for endpoint update HE.net password, plaintext, obsolete, used for endpoint update ![]() HE.net username which you use to login into tunnelbroker, not the User ID shown after you have login in, plaintext, used for endpoint update HE.net global tunnel ID, used for endpoint update Type Of Service : either “inherit” (the outer header inherits the value of the inner header) or an hexadecimal value. Whether to create an IPv6 default route over the tunnel Define which Interface, for example WAN, should be used for outgoing IPv4 traffic to the Remote IPv4 Address Routed IPv6 prefix for downstream interfaces (Barrier Breaker and later only) Local IPv6 address delegated to the tunnel endpoint Please check if this is still true or not: At the time of writing, only the static protocol type is allowed for aliases. Selects the interface to attach to for stacked protocols (tun over bridge over eth, ppp over eth or similar).ģ: attach to layer 3 interface ( tun*, ppp* if parent is layer 3 else fallback to 2)Ģ: attach to layer 2 interface ( br-* if parent is bridge else fallback to layer 1)ġ: attach to layer 1 interface ( eth*, wlan*) Specifies the logical interface name of the parent (or master) interface this alias belongs to must refer to one of the defined interface sectionsīroadcast address (autogenerated if not set) IPv6 routing table for routes of this interface, see ip -6 rule show ip -6 route show table IPv4 routing table for routes of this interface, see ip rule show ip route show table Specifies whether ip address, route, and optionally gateway are assigned to the interface regardless of the link being active ('1') or only after the link has become active ('0') when set to '1', carrier sense events do not invoke hotplug handlers Specifies whether to send Router Solicitations on this interface deprecated: ![]() Specifies whether to accept IPv6 Router Advertisements on this interface deprecated: Specifies whether to enable (1) or disable (0) IPv6 on this interface (Barrier Breaker and later only) Specifies whether to bring up interface on boot Override the default MTU on this interface Override MAC address of this interface, e.g. If set to bridge, creates a bridge containing the given ifname and wireless interfaces assigned using the network option in wireless configuration This option may be empty or missing if only a wireless interface references this network or if the protocol type is pptp, pppoa or 6in4 Do not specify wireless interfaces as their names and behavior can be dynamic and unpredictable, instead assign wireless interfaces to bridges using the network option in wireless configuration. Physical interface name such as eth0.1, eth2, tun0 to assign to this section, or list of interfaces if type bridge is set. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |